Tanaka TCG 23ECP Instructions De Sécurité Et Mode D'emploi page 12

English
● Do not use with the engine set at low
speeds. If the engine speed is low, grass
may wrap around the attachment, causing
the clutch to slip which could result in clutch
abrasion.
● With nylon cord cutters, always use over
5-7/8" (15 cm) of cord. If the length of
the cord is too short, rotation speed will
increase and may cause damage to the
nylon cord cutter. As the curved drive shaft
tube model in particular is not equipped with
a deceleration mechanism, the possibility
of increased rotation speed for the cutting
attachment is high.
Stopping (Fig. 15)
Decrease engine speed and run at an idle for a few
minutes, then turn off ignition switch (10).
WARNING
A cutting attachment can injure while it
continues to spin after the engine is stopped
or Throttle trigger is released. When the
unit is turned off , make sure the cutting
attachment has stopped before the unit is
set down.
12
10
Fig. 15
MAINTENANCE
MAINTENANCE, REPLACEMENT OR REPAIR
OF THE EMISSION CONTROL DEVICES AND
SYSTEMS MAY BE PERFORMED BY ANY NON-
ROAD ENGINE REPAIR ESTABLISHMENT OR
INDIVIDUAL.
Carburetor adjustment (Fig. 16)
The carburetor is a precision part that mixes air and
fuel, and it is designed to ensure high performance
from the engine. Before the tool is shipped from
the factory, its carburetor is adjusted during a
test run. Only make adjustments if it is necessary
because of environmental conditions (the climate or
atmospheric pressure), the type of fuel, the type of
twocycle oil, etc.
WARNING
● Because the carburetor is manufactured
with a high degree of precision, do not
disassemble it.
● For this product, the only setting of the
carburetor that can be adjusted is the idle
speed (T).
● Never start the engine without the complete
clutch cover and tube assembled! Otherwise
the clutch can come loose and cause
personal injuries.
T = Idle speed adjustment screw.
Idle speed adjustment (T)
WARNING
● When the engine is stopped, do not
excessively turn the idle speed adjustment
screw (T) in
Otherwise, when the engine starts, the
cutting attachment may unexpectedly rotate
and cause an injury.
● Do not adjust the idle speed adjustment
screw (T) for any reason other than to adjust
the idling.
Fig. 16
a clockwise direction.