Bevel Gear; Technical Data - Husqvarna BCA850 Manuel D'utilisation

Maintenance
Make sure that the screws and nuts are tight.
Check that the bevel gear is filled three-quarters full with lubricant. Fill if neces-
sary using special grease.
To sharpen the grass knife and grass
blade
WARNING: Stop the engine. Use protective
gloves.
• To sharpen the grass knife or grass blade correctly,
refer to the instructions that come with the cutting
attachment.
• Sharpen all edges equally to keep the balance.
• Use a single-cut flat file.
WARNING: Always discard a blade that is
damaged. Do not try to make a bent or
twisted blade straight and use it again.

Technical data

325iLK + Brushcutter attachment BCA850
Motor
Speed of output shaft, 1/min
Weight
Weight, kg
Cutting
Cutting width, mm
2
Noise emissions
1
Revolutions/minute
2
Noise emissions in the environment measured as sound power (LWA) in conformity with EC directive
2000/14/EC. Reported sound power level for the machine has been measured with the original cutting attach-
ment that gives the highest level. The difference between guaranteed and measured sound power is that the
guaranteed sound power also includes dispersion in the measurement result and the variations between dif-
ferent machines of the same model according to Directive 2000/14/EC.
12
Technical data
1

Bevel gear

The bevel gear is filled to ¾ with grease at the factory.
Before use, make sure that the grease level has not
changed. Use Husqvarna special grease if it is
necessary to fill up. Do not change the grease in the
bevel gear. Let servicing personnel do the repair of the
bevel gear.
5800
3.7+1.6
Ø 255
Daily Weekly Monthly
X
X
1340 - 001 - 20.12.2019