Operation; Work Position - Husqvarna BCA850 Manuel D'utilisation

To balance the product
WARNING: Always use the harness when
you operate the product. The harness gives
maximum control of the product and
decrease the risk to become fatigued in your
arms and back.
• Put on the harness.
• Connect the support hook of the product to the
harness and keep the cutting attachment parallel
with the ground.
Introduction
WARNING: Read and understand the safety
chapter before you use the product.
To adjust the harness
WARNING: Always attach this product to the
harness correctly. If not, you cannot control
the product safely and this can result in
injury to you or others. Do not use a harness
with a defective quick release.
WARNING: If an emergency occurs, let go
of the harness and the product and let it fall
to the ground.
1. Put on the harness.
2. Adjust the harness for the best work position.
3. Adjust the harness until the cutting attachment is
parallel to the ground.
4. If the operation is to cut grass, let the cutting
attachment stay lightly on the ground. Adjust the
harness clamp to balance the product correctly.
1340 - 001 - 20.12.2019
• The product is correctly balanced when the blade is
at cutting height near the ground.

Operation

Work position

• Hold the product with 2 hands.
• Hold the product on the right side of your body.
• Keep the cutting attachment below waist level.
• Keep body parts away from the hot surfaces.
• Keep body parts away from the cutting attachment.
Before you operate the product
• Examine the work area to make sure that you know
the type of terrain, the slope of the ground and if
there are obstacles such as stones, branches and
ditches.
• Do an overhaul inspection of the product.
• Do the safety inspections, maintenance and
servicing that are given in this manual.
• Make sure that all covers, guards, handles and the
cutting equipment are correctly attached and not
damaged.
• Make sure that there are no cracks at the bottom of
the grass blade teeth or by the center hole of the
blade. Replace the blade if it is damaged.
• Examine the support flange for cracks. Replace the
support flange if it is damaged.
• Make sure that the locknut can not be removed by
hand. If you can remove it by hand, it does not lock
9