Cleaning And Maintenance - Linea 2000 Domo DO221SV Mode D'emploi

CLEANING AND MAINTENANCE

CLEANING THE MACHINE
Clean the machine with a slightly moist soft cloth. Dry the machine off well. Never submerge
the machine in water!
CLEANING THE DUST RESERVOIR
1. Press the dust reservoir unlock button to remove it from the vacuum cleaner.
2. Then take the filters out of the dust reservoir. Empty the
3. Take part A from part B.
4. The dust reservoir, part A and part B can be cleaned under running water. Do take care to
dry them completely before using them again in the
We advise replacing the filters regularly to ensure an optimal operation of the machine. Dirty
filters will reduce the suction power drastically. After every cleaning, clean the dust reservoir
and the filters to extend the life span of your machine.
CLEANING THE FLOOR BRUSH
1. Remove the floor nozzle from the upright vacuum cleaner. Press the
the back of the floor nozzle and remove it from the machine.
2. Unclip the cover on the left side of the floor nozzle.
3. Remove the
4. Remove hairs and other dirt that have wrapped around the floor
brush. If you do not clean the floor brush regularly, it will become
damaged and your machine will become unusable.
5. The rotating floor brush may be rinsed off under running water.
Make sure that it is completely
6. Place the floor brush back into the floor nozzle when it is clean.
7. Click the closure valve back into place to close it.
8. Push the nozzle back onto the stick. The machine is now again ready for use.
Stuck hairs can
brushes.
26
DO221SV
2
rotating floor brush from the floor nozzle.
dry before using it.
damage the machine or your floor. Always remove the hairs stuck on the
dust reservoir.
machine.
A
B
release button at