Replacing The Lamp - Electrolux ERT1600AOW Notice D'utilisation

30 www.electrolux.com
Problem
Water flows on the
ground.
The temperature in
the appliance is too
low.
The temperature in
the appliance is too
high.
The temperature in
the refrigerator is too
high.

REPLACING THE LAMP

CLOSING THE DOOR
1. Clean the door gaskets.
2.
If necessary, adjust the door. Refer to
"Installation".
Possible cause
Products prevent that wa-
ter flows into the water col-
lector.
The melting water outlet
does not flow in the evapo-
rative tray above the com-
pressor.
The temperature regulator
is not set correctly.
The temperature regulator
is not set correctly.
The door is not closed cor-
rectly.
The product temperature is
too high.
Many products are stored
at the same time.
There is no cold air circula-
tion in the appliance.
1.
2.
3.
4.
5.
6.
7.
8.
3.
Solution
Make sure that products do
not touch the rear plate.
Attach the melting water
outlet to the evaporative
tray.
Set a higher temperature.
Set a lower temperature.
Refer to "Closing the door".
Let the product temperature
decrease to room tempera-
ture before storage.
Store less products at the
same time.
Make sure that there is cold
air circulation in the appli-
ance.
Disconnect the mains plug from the
mains socket.
Remove the screw from the lamp cov-
er.
Remove the lamp cover (refer to the il-
lustration).
Replace the used lamp with a new
lamp of the same power and specifi-
cally designed for household applian-
ces. (the maximum power is shown on
the lamp cover).
Install the lamp cover.
Tighten the screw to the lamp cover.
Connect the mains plug to the mains
socket.
Open the door. Make sure that the
lamp comes on.
If necessary, replace the defective door
gaskets. Contact the Service Center.