Fitting The Inverter; Tools Required; Mounting Instructions - Dometic Waeco SinePower MSI2312T Instructions De Montage Et De Service

Fitting the inverter

8 Fitting the inverter
8.1

Tools required

For the electrical connection you will need the following tools:
 Crimping tool
 3multi-coloured, flexible connection cables. Determine the necessary
thickness from the table in chapter "Connecting the inverter" on page 43.
 Cable lugs and conductor sleeves
For fastening you will require the following tools:
 Machine bolts (M4) with washers and self-locking nuts or
 self-tapping screws or wood screws.
8.2

Mounting instructions

When selecting the installation location, observe the following instructions:
 The inverter can be mounted horizontally or vertically.
 The inverter must be installed in a place that is protected from moisture.
 The inverter may not be installed in the presence of flammable materials.
 The inverter may not be installed in a dusty environment.
 The place of installation must be well ventilated. A ventilation system must
be available for installations in small, enclosed spaces. The minimum
clearance around the inverter must be at least 25 cm (fig. 2, page 3).
 The air intake on the underside or the air outlet on the back of the inverter
must remain clear.
 For ambient temperatures higher than 50 °C (such as in engine or heating
compartments, or direct sunlight), the heat from the inverter under load
can lead to automatic shutdown.
 The device must be installed on a level and sufficiently sturdy surface.
42
SinePower
EN