NORAUTO HT7101 Mode D'emploi page 127

Connecting the Maintainer and Maintaining the Battery
with the Terminal Rings
The charger's crimped terminal rings are color-coded (RED-
POSITIVE and BLACK-NEGATIVE). These rings connect directly to
the corresponding connectors on the battery posts.
IMPORTANT: Before start connecting, Unplug
the battery maintainer AC cord from the AC outlet.
Disconnect the crimped terminal rings from the unit at
output cord connector.
The maintainer remains in Float Charge Mode as long as
the charger/maintainer is connected to the battery and is
plugged into a functioning AC mains socket.
1
NUT
CONNECTOR
1. Remove the nuts from the bolts
of the battery post's connectors.
2. Position the red terminal ring on
the bolt of the positive battery
post connector.
3. Position the black terminal ring
on the negative battery post
connector; then replace the
nuts.
2
Connect the battery terminal rings
connector to the unit connector,
as far away from the battery as
possible.
TERMINAL
RING
12V or 6V
BOLT
Slide the voltage selector to
proper setting
Attention: If the voltage selector
switch is selected incorrectly,
the charger/maintainer does not
charge the battery. The unit has
no any indications. Make sure
the voltage selector switch is set
correctly.
● Plug the unit onto the power
socket.
● Observe the blinking GREEN
LED that indicates the unit is
operating.
● Monitor the battery from time
to time.
● When the Green LED stop
blinking and remain solid,
battery fully charged.
127
3
4