Initial Operation - Bosch LR 2 Professional Notice Originale

OBJ_BUCH-821-003.book Page 16 Thursday, December 20, 2012 12:37 PM
16 | English
Operation

Initial Operation

 Protect the measuring tool against moisture and direct sun light.
 Do not subject the measuring tool to extreme temperatures or variations in
temperature. As an example, do not leave it in vehicles for long time. In case of
large variations in temperature, allow the measuring tool to adjust to the ambient
temperature before putting it into operation. In case of extreme temperatures or
variations in temperature, the accuracy of the measuring tool can be impaired.
Setting Up the Measuring Tool (see figure A)
Position the measuring tool at least 5 m away from the cross-line laser. Switch on the
pulsating function on the cross-line laser, and select horizontal or vertical operation.
Note: Do not select cross-line operation, as otherwise faulty indications on the height
of the laser beam can occur.
Position the measuring tool in such a manner that the laser beam can reach the recep-
tion area 10. Align the measuring tool in such a manner that the laser beam runs lat-
erally through the reception area (as shown in the figure).
Switching On and Off
 A loud audio signal sounds when switching on the measuring tool. Therefore,
keep the measuring tool away from your ear or other persons when switching
on. The loud audio signal can cause hearing defects.
To switch on the measuring tool, press the On/Off button 2. All display indicators as
well as all LEDs light up briefly and an audio signal sounds.
To switch off the measuring tool, press the On/Off button 2 again. Before switching
off, all LEDs briefly light up.
When no button is pressed on the measuring tool for approx. 20 minutes and when no
laser beam reaches the reception area 10 for 20 minutes, the measuring tool auto-
matically switches off in order to save the battery. The switching off is indicated by
brief lighting up of all LEDs.
Selecting the Setting of the Centre Indicator
With button 1, you can specify with which accuracy the position of the laser beam is
indicated as central on the reception area:
– "Fine" adjustment (indication g on the display),
– "Coarse" adjustment (indication f on the display).
Whenever switching on the measuring tool, the accuracy level "coarse" is set.
1 609 92A 05F | (20.12.12) Bosch Power Tools