Christopeit Sport ET 2 Notice De Montage Et D'utilisation page 16

Step 6:
Installation of the right and left pedal (24L+24R) at pedal arms
(13L+13R).
1. Screw the left pedal (24L) into the threaded hole on the left hand side of
the pedal arm (25L) and tighten fi rmly.
(Note: The threaded part of the left pedal must be screwed anticlock-
wise into the threaded hole of the pedal crank.) The pedals are marked
"R" for right and "L" for left.
2. Screw the right pedal (24R) into the threaded hole on the right hand
side of the pedal arm (25R) and tighten fi rmly.
(Note: Right and left are specifi ed as viewed seated on the machine
during training. It must also be observed that the threaded part of the
right pedal must be screwed clockwise into the threaded hole of the
pedal crank.)
3. Then attach the pedal straps left and right to the respective pedals.
Step 7:
Installation of the power adaptor (67).
1. Please insert the plug of adaptor (67) to the jack (68) of chain guard.
2. Please insert the plug of adaptor (67) to the jack of wall power
(230V~/50Hz).
Step 8:
Checks
1. Check the correct installation and function of all screwed and plug con-
nections. Installation is thereby complete.
2. When everything is in order, familiarise yourself with the machine at a
low resistance setting and make your individual adjustments.
Note:
Please keep the tool set and the instructions in a safe place as these may
be required for repairs or spare parts orders becoming necessary later.
16