Assembly; Unpacking The Generator; Install Wheel Kit - Briggs & Stratton ELITE Série Manuel D'utilisation

ASSEMBLY

ASSEMBLY
Your generator requires some assembly and is ready for
use after it has been properly serviced with the
recommended oil and fuel.
If you have any problems with the assembly of your
generator, please call the generator helpline at
1-800-743-4115. If calling for assistance, please have the
model, revision, and serial number from the data tag available.
See "Know Your Generator" for data tag location.

Unpacking the Generator

1. Set palleted carton on a rigid flat surface.
2. Carefully cut bands around shipping carton.
3. Lift carton off generator.
4. Remove all packing material, carton fillers, etc.
5. Remove generator from shipping pallet.
Figure 1 — Install Wheel Kit
Axle
Wheel Spacers
Wheel
Washer

Install Wheel Kit

The wheel kit is designed to greatly improve the portability
of your generator.
NOTE: Wheel kit is not intended for over-the-road use.
You will need the following tools to install these components:
• 7/16" and 13mm wrench
• Socket wrench with a 7/16" and 13mm socket
• Pliers
• Safety glasses
Refer to Figure 1 and install the wheel kit as follows:
1. Tip generator so that engine end is up.
2. Slide axle through both mounting brackets.
3. Slide a wheel spacer on each side of axle.
4. Place a wheel on each side with air valve facing out.
Hex Nut
Vibration
Mount
Flat
E-Ring
7
Support Leg
Flat Washer
Lock Washer
20mm
20mm Cap Screw
Cap
Screw