Haussmann 325598 Manuel D'utilisation page 14

OPERATING INSTRUCTIONS
The guard must always be on the tool to
protect the user.
1. Fitting the Guide Wheel (for edging)
Attach the guide wheel onto the underside of
the guard as shown in Fig. 2 using the two 8
mm long screws provided.
2. Guard Fitting
Attach the guard to the motor housing by
placing the guard over the cutting head and
securing it in place by using the four 0.55"
(14mm) long screws provided (see Fig 3).
A
Check to ensure the guard is properly located
and secure.
The guard has a very sharp cutting edge that
is used for cutting the trimmer line. Take great
14
Fig 2
Fig 3
Fig 3a
care when attaching the guard. (see Fig
3a)
3. Spacer Guard Fitting
Attach the wire guard to the plastic guard by
inserting the ends of the wire into the brackets
on the top of the plastic guard (see Fig 4a and
4b). The guard can be raised and lowered as
required.
Fig 5a
Fig 5b
4. Auxiliary Handle Fitting
Attach the auxiliary handle to the support
bracket on the trimmer shaft. Insert the
Fig 4a
Fig 4b