Storage And Unpacking; Controls - Saeco DA 7P PLUS Mode D'emploi Et D'entretien

English

6 - STORAGE AND UNPACKING

MACHINE
usually found in the dump box of the machine. Remove the bag.
List of accessories supplied :
• Cup reduction ring Ø 58 mm (Paragraph 9.2)
• Safety sensor key (Paragraph 10)
• G 13 coin conveyor supplied with coin channel, fastening screws and nuts (Paragraph 8.2)
• G 26 coin conveyor supplied with coin channel, fastening screws and nuts (Paragraph 8.2)
• No. 4 fastening screws and nuts for the coiner (Paragraph 8.6)
• No. 1 metal adhesive cable stopper for the G 26 coiner cables (paragraph 8.7)
• Product labels, adhesive price labels and operating instruction label (Paragraph 8.9)
• No. 1 brew group key (Paragraph 10)
• No. 1 whipper fan key (Paragraph 10.2)
• No. 1 nation key (paragraph 8.4)
• No. 1 operating and maintenance manual
• No. 1 graphic image (Paragraph 8.9)

7 - CONTROLS

• Controls
COINS ACCEPTED
ESPRESSO
LONG
ESPRESSO
ESPRESSO WITH
A DASH OF MILK
CAPPUCCINO
CHOCOLATE
LEMON TEA
MILK
G 13 Model Fig. 5
24
CABINET
COINS ACCEPTED
ESPRESSO
LONG
ESPRESSO
ESPRESSO WITH
A DASH OF MILK
CAPPUCCINO
CHOCOLATE
LEMON TEA
MILK
G 26 Model Fig. 5
Storage
• The machine is packed into a sturdy cardboard box with a rein-
forced platform, as shown in figure 4. The boxed machine can
be stored in cool, dry, dust-free locations.
Warning : Do not stack more than one box on top of another.
Unpacking
• Place the boxed machine on the installation site, cut the straps
andremove the box.If the machine was delivered with its optional
matching cabinet, unpack and assemble the cabinet. Make sure
that the floor is flat, dry, and able to withstand the weights ot the
Fig. 4
machine and cabinet. Check the contents of the accessories bag,
• Main switch: on the backside of the machine, bottom right (Fig. 3-7).
• Selection panel: consists of 7 buttons (45) corresponding to the number of
beverages, identified respectively as A - B - C - D - E - F - G (fig. 5).
• Display (40): shows the sum of the coins inserted.
• Green LEDs (44) beside the beverage selection buttons : they turn on when
the corresponding selected beverage can be dispensed (i.e. when coins
inserted reach or exceed the price shown).
N.B. Should the machine be programmed to dispense beverages free of
charge, the green LEDs will always be on.
• Red LEDs (43) beside the beverage selection buttons : they turn on when
the corresponding beverage is empty.
• Green LED (42) "READY FOR USE": Shows the machine is ready to operate.
The green leds light up intermittently.
• Red LED (41) "WATER EMPTY":
Shows the machine cannot operate because the water tank is empty.
• Coin return button (38): Press the button for coin return, or if applicable,
for change.
• Stirrer dispenser button (36): Press the button to dispense a stirrer (35).
The machine can be programmed to set both the coin value and the
price.
The first 4 buttons (highlighted by the symbol) are used for
programming operations; entered data are shown on the display
40.
For additional instructions, see paragraph 8.6.