Technical Problem - Novy 7550 Mode D'emploi Et D'installation

After 200 cooking hours, an orange lamp on the hood
indicates that the monoblock filters need cleaning.
Remove the Monoblock recirculation filter
When you replace the monoblock filters after cleaning,
press the [+] and [-] buttons simultaneously for 5
seconds to reset the cleaning indicator.
If you do not do this, the green light will continue to
shine when you turn on the extraction hood.
Regenerate the Monoblock recirculation filter:
• The Monoblock can be regenerated up to 12 times.
This is done in the oven.
• Place the filter in the oven for 1 hour at 120°C. Pro-
vide sufficient fresh air in the room where the oven
has been placed, as smells can be released.
Smells can be released when baking certain kinds
of fish. The best solution for this is to immediately
regenerate the filter.
Place the Monoblock recirculation filter
Place the monoblock filters back in the openings
above the extraction hood. Slide the grates back into
place above the monoblock filters (with the grip turned
inward).
Reset the Monoblock recirculation indication
When you replace the monoblock filters after cleaning,
press the [+] and [-] buttons simultaneously for 5
seconds to reset the cleaning indicator.
If you do not do this, the orange light will continue to
shine when you turn on the extraction hood.
4.3 Maintenance of of the cookerhood
Use a soft, wet cloth and a mild detergent to clean the
hood. Then rub dry with a dry, soft cloth to avoid stains.
Clean the Hi-Macs light diffuser
Never use aggressive, abrasive detergents or
sponges.
Do not use an abrasive or scourer.

4.4 Technical problem

In the event of a malfunction, you can contact your
(kitchen) supplier and/or the Novy Customer Service
Department. In order for the Customer Service
Department to reply quickly and precisely you must to
tell them which type of extraction hood you have.
The model number can be found on a sticker on
the interior of the extraction hood.
This is visible as soon as you take the filter out
of the extraction hood.
You can write down the model number here:
Model number: ............................
EN 18