Remote Control - Novy 7550 Mode D'emploi Et D'installation

Use the 30 minutes run-out time to make sure that
the monoblock filter can properly absorb the cooking
smells.
Switch off without delay
Push button twice.
Auto-Stop
To avoid that the hood will function during a too long
period, it will switch off automatically after 3 hours
(when no changes to the controls have been made).
Only the motor will turn off automatically. The lighting
will remain on in the mood mode.
Motor speed
In order to increase the speed of the motor, press the
button. In order to decrease the speed, press the
button . The motor speed can be set to 4 speeds.
You can select the required position depending on the
vapour production while cooking.
A self-rectifying thermal contact makes sure that
the motor is switched off when overheated. The motor
will switch on again after is has cooled down. The
cause of the overheating needs to be determined. This
may be, for example, that the contents of the pan have
caught fire, the motor fan is blocked or an object is
(partly) closing off the exhaust opening.
3.2 Lighting
With respect to the lighting you can choose between
the cooking mode and the mood mode.
Cooking mode
The cooking mode provides optimum lighting for
cooking. This mode has by default a maximum light
intensity at the bottom of the hood and a lower light
intensity on the sides. Press key
the cooking mode on or off.
Cooking mode light intensity
When the cooking mode is active, you can dim
or intensify the light by pressing and holding key
. Release key when the required light intensity has
been reached.
You cannot fully dim the light of the cooking mode,
because then there will not be sufficient light to cook.
Change the colour temperature in the cooking mode
You can change the colour temperature into cold
light by simultaneously pressing keys
seconds. Release both keys when the required colour
temperature has been reached.
You can change the colour temperature into warm
light by simultaneously pressing keys
seconds. Release both keys when the required colour
temperature has been reached.
After having switched off the cooking mode, the last
set value will always be remembered. In this way your
preference will be used every time when switching on
the hood.
or key to switch
and for 4
and for 4
Mood mode
The mood mode provides optimum lighting for creating
a nice atmosphere. This mode has by default a lower
light intensity than the cooking mode both at the
bottom and along the sides of the hood. Press key 5 to
switch the mood mode on or off.
Mood mode light intensity
When the mood mode is active, you can dim or intensify
the light by pressing and holding key 5. Release key 5
when the required light intensity has been reached.
Change the colour temperature in the mood mode
You can change the colour temperature into cold
light by simultaneously pressing keys 5 and
seconds. Release both keys when the required colour
temperature has been reached.
You can change the colour temperature into warm light
by simultaneously pressing keys 5 and
them for 4 seconds. Release both keys when the
required colour temperature has been reached.
After having switched off the mood mode, the last set
value will always be remembered. In this way your
preference will be used every time when switching on
the hood.

3.3 Remote control

The remote control for hood is preinstalled and ready
for use.
If the set code disrupts other transmitters,
another code can be selected using the remote
control. There are 10 different codes in total.
Change the code
• First switch off the power supply of the hood. Do
this by deactivating and reactivating the on/off
switch. The set-up mode will now be active for 3
minutes. The new code must be set up within these
3 minutes.
• Simultaneously press
mote control flashes as many times as the selected
code. Repeat this step until you have reached the
required code (there are 10 code options in total).
• Press the key on the remote control within 10
seconds to confirm the settings. The cookerhood
and the remote control are now in line with each
other.
Change the batteries:
• For changing the batteries unscrew the plastic
cover, remove the old batteries and insert the new
ones. Pay attention to the polarity marking given in
the battery compartment (figure 4).
• Empty batteries are not to be disposed of in the
household refuse, but they are to be handed in as
chemical waste.
for 4
and holding
and . The lamp on the re-
EN 16