Technical Problem - Novy 6830/16 Mode D'emploi Et D'installation

Masquer les pouces Voir aussi pour 6830/16:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

1. Carefully press the spotlight holder; next, remove
the spotlight holder by means of a tilting movement.
2. Removing the LED lamp:
A. First disconnect the cable to the LED to be replaced.
Disconnect by means of releasing the lock, by ap-
plying light pressure while at the same time pulling
away.
B. Next, remove the LED to be replaced by making a
gentle rotating movement to the left.
3. Mounting the new LED:
A. Place the new LED light into the locking ring.
B. Make a rotating movement to the right until the LED
light is locked.
C. Connect the power cable.
D. Place the spotlight holder back in the cooker hood
and reconnect the power.
Change in colour temperature with LED-lighting
First make sure that the power supply of the hood has
been disconnected. Remove the plug from the hood or
switch off the power group.
The colour of the LED-lighting has been set to 2700K
(warm white) by default. If the colour is to be changed
to 4000K (neutral white), follow the instruction given
below:
• Open the bottom plate at the bottom of the hood.
• Press with two hands against the side of the inox
lamp holder and carefully pull down simultaneously,
so you get access to the lighting on the inside.
• The wiring has been connected to the LED-lamp
with a connector.
• Disconnect the connector from the LED-lamp and
move the wiring to the other free connection on the
lamp.
• Repeat this for all four LED-lamps.
• Then close the inox lamp holder again.
The colour of the LED-lighting has now been changed
from 2700K to 4000K.

4.5 Technical problem

In case of technical problems please contact Novy
Service Department:
• For Belgium: Tel.: 056/36.51.02
• For France: Tel.: 03.20.94.06.62
• For Germany: Tel.: 0511.54.20.771
For all other countries: your local installor or Novy Bel-
gium: +32 (0)56/36.51.02
Please supply us with the model number of your hood.
The model number can be found on the engra-
ved plaque behind the filter.
You can make a note of the number here:
.................................
Dimensions: p. 21-22
Electrical scheme: p. 23
EN 20

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

6831/166840/166841/16

Table des Matières