Replacing The Batteries - Dometic MS660 Instructions De Montage Et De Service

Using MagicSafe
11.11

Replacing the batteries

Please observe the following instructions for batteries:
!
WARNING!
Keep the batteries out of reach of children.
• Only use leak-proof batteries that are suitable for electronic devices.
• Never attempt to do the following with batteries:
– recharge them,
– open them or
– throw them in fires.
• Dispose of old batteries appropriately.
Changing the battery in the hand-held transmitter
If the hand-held transmitter's range is reduced noticeably or if the control LED flickers
during transmission, the battery needs to be replaced.
➤ Undo the screw on the bottom of the hand-held transmitter.
➤ Open the hand-held transmitter.
A
NOTICE!
Ensure the polarity of the batteries is correct when inserting. The positive
pole is at the top.
➤ Change the battery (battery type CR 2032, 3 volts).
➤ Refit the lid on the hand-held transmitter and re-insert the screw.
Changing the battery in the radio motion detector (accessory)
➤ Press the housing of the motion detector in slightly on both sides and remove it.
➤ Change the battery (9 volt battery).
➤ Put the housing back onto the rear wall and click it into place.
52
MS660
EN