Using Magicsafe - Dometic MS660 Instructions De Montage Et De Service

Using MagicSafe

Programming functions
The functions are programmed by pressing the button "Lock" or "Unlock"
repeatedly in accordance with the number of the function, see list, page 36.
Example: You wish to activate the convenience locking function. This is function 4.
Press the "Unlock" button 4 times to activate.
The status LED goes out briefly each time the button is pressed to confirm the
selection. To confirm the programming step, the status LED goes out for 2 sec.
The preferred value is saved.
➤ Perform all the required programming steps.
➤ To end programming, switch the ignition on.
11 Using MagicSafe
11.1 Function table
The following table lists all of the functions and how you can activate them.
Function
Activating
Deactivating
Manual lock-
ing/unlocking of the
doors from the inside
Activating without
interior monitoring
Panic mode
Convenience output
Convenience output
42
Condition
Ignition off
Ignition off
Alarm system activated
Ignition on
Ignition off
Ignition off
Alarm system activated
Ignition off
Alarm system activated
Ignition off
Alarm system
deactivated
"Lock" "Unlock"
button button
●
●
●
● ● (30 sec.)
● ● (1 sec.)
MS660
"COM-
FORT"
button
●
●
EN