Installing The Controller - Dometic MS660 Instructions De Montage Et De Service

Installing MagicSafe
7.2

Installing the controller

➤ Select a suitable installation location (fig. 6, page 5).
I
NOTE
When selecting the installation location, observe the following
instructions:
➤ Install the control unit
– in the vehicle interior
– with the main connection cable facing downwards
– under the dashboard
– not in areas where strong electrical fields could cause interference,
e. g. ignition cables or central control electronics,
– not directly next to ventilator nozzles.
➤ Where possible, use existing holes in the vehicle.
➤ Screw the control unit firmly to the vehicle with the screws supplied or use
double-sided adhesive tape.
7.3 Installing the ultrasonic module
➤ Select a suitable installation location close to the control unit.
➤ Screw the ultrasonic module firmly to the vehicle with the screws supplied or use
double-sided adhesive tape.
7.4 Installing the ultrasonic sensors
➤ Select a suitable installation location on the left and right A-pillars.
➤ Align the ultrasonic sensors with the middle of the rear window.
➤ Tightly fasten the ultrasonic sensors using the screws provided.
➤ Lay the cables down along the A pillar and over the dashboard to the ultrasonic
module.
22
MS660
EN