Dometic MS660 Instructions De Montage Et De Service page 38

Programming MagicSafe
Function 2 (Voltage drop sensor)
This function allows the voltage drop sensor to be activated or deactivated.
The sensor reacts to a vehicle battery load of at least 12 watts and triggers an alarm.
Function 3 (Signal duration of the door locking contacts)
In some vehicles, (for example Mercedes-Benz), an activation time of 0.7 sec. might
not be sufficient to completely activate the central locking system. In such cases, you
need to set the control time to 3 sec. using this software function.
Function 4 (Convenience locking function)
This activates or deactivates the convenience locking function, see chapter "Using
the convenience locking function" on page 49.
Function 5 (Starter circuit breaker)
This function allows you to activate or deactivate the starter circuit breaker.
The starter circuit breaker is activated:
• 30 sec. after the ignition was switched off ("Standby" mode, see chapter
"MagicSafe operating modes" on page 20)
• 60 sec. after the ignition was switched off using the remote control ("Standby"
mode, see chapter "MagicSafe operating modes" on page 20)
This function can only be used when function 13 is programmed to "Starter circuit
breaker".
Function 6 (Automatic reactivation)
This function reactivates the alarm system if this was deactivated by mistake or
without being noticed. This occurs when the alarm system was deactivated and no
door was opened within approx. 40 sec.
Function 7 (Self-activation)
If the function is programmed to "On", the alarm system activates itself automatically
when the ignition is switched off, approx. 10 sec. after the last door was closed.
Deactivation remains possible using the hand-held sensor.
Function 8 (Circuit time for the convenience output)
You can choose between 20 sec. (e. g. for shutting off the dipped headlights,
Coming Home function) or 1 sec. (e. g. for opening the tailgate). This function can
only be used when function 18 is programmed to "Convenience output on".
38
MS660
EN