Dometic MS660 Instructions De Montage Et De Service page 29

MS660
Black (P11)
➤ Connect this cable to earth (terminal 31).
Red (P12)
Connects the key holder to the control unit.
Yellow (P13)
I
NOTE
The boot contact switch only has to be connected if the lighting for the
passenger compartment (interior light) remains dark when the boot is
opened. In this case, use two diodes in the yellow cable as specified in
the wiring diagrams (fig. a 20, page 7).
➤ Connect this cable to the door contact switch on the driver's door and,
if required, to the boot contact switch as well.
The factory setting allows for a switch which is closed when the door is open. If
the switch is open when the door is open, this can be programmed in the control
unit, see chapter "Function 16 (Door contact/boot input)" on page 40.
I
NOTE
If it is not possible to connect the yellow cable to the door contact switch
in your vehicle, you have to connect the yellow cable to earth when
programming new hand-held transmitters, electronic keys or radio
sensors (see chapter "Learning the hand-held transmitter, electronic key
and radio sensors/reading the PIN code" on page 46).
Black (P14)
Connects the key holder to the control unit.
White + black (P15)
The white cable provides an additional earth-controlled output for optional
accessory modules.
The black cable is the earth cable for the ultrasonic module.
EN
Connecting the power to MagicSafe
29