Dometic MS660 Instructions De Montage Et De Service page 46

Using MagicSafe
11.4 Controlling the central locking with MagicSafe
I
NOTE
When locking using the hand-held transmitter, the ignition must be
switched on. Otherwise the alarm system will be activated as well.
If your vehicle features central locking, you can lock or unlock doors automatically
from the inside. This function has been factory-set to deactivated. To activate it,
process as follows:
➤ Program software function 11 "Locking/unlocking with ignition" to "On", see
chapter "Software functions" on page 36.
When the ignition is switched on, the central locking will now lock the vehicle when
the "Lock" button is pressed for 3 sec. The alarm system remains deactivated.
If you switch the ignition off, all doors will be unlocked without delay.
11.5 Learning the hand-held transmitter, electronic key
and radio sensors/reading the PIN code
I
NOTE
• Learn all hand-held transmitters, electronic keys and radio sensors
(accessory) which you wish to use during the same programming
phase. This also applies for hand-held receivers which you have used
previously, or radio sensors which have already been paired!
• Learn the hand-held transmitter and the electronic key first, then – if
applicable – the radio motion detector (accessory) and then the
radio magnetic sensors (accessory).
Proceed as follows to learn hand-held transmitters, electronic keys as well as radio
sensors (e. g. radio motion detector, radio magnetic sensors – accessory):
Switching to learning mode
➤ Deactivate the alarm system by pressing the "Unlock" button.
➤ Open the driver's door.
➤ If you have not connected a door contact switch, you need to connect the yellow
cable belonging to MS660 to an earth point.
Maintain this connection throughout the entire programming process.
➤ Switch on the ignition.
➤ Press and hold down the "COMFORT" button.
46
MS660
EN