Key To Symbols; Simplified Eu Declaration Of Conformity - Urmet 1717/32 Notice D'installation

This product is intended to be powered by either any external power supply units,
through the connector M1 on the board CS1717-014 (15W, 24 / 48 V
the connector CN505 whose power supply conforms to the limited power source (LPS)
requirements and is protected against short circuits and power surges in accordance with
the EN 62368-1:2014+A11 requirements.
(#) 48 V version differs from the previous 24 V
48V
product:
If a local power supply is used, do not connect the LAN input to the switch POE outputs.

KEY TO SYMBOLS

Symbol
Direct input voltage
See the installation manual of the device

SIMPLIFIED EU DECLARATION OF CONFORMITY

Hereby, URMET S.p.A. declares that the radio equipment type:
IP 7'' TOUCHSCREEN VIDEO DOOR PHONE Ref. 1717/32 and Ref. 1717/34
is in compliance with Directive 2014/53/EU.
The full text of the EU declaration of conformity is available at the following internet address:
www.urmet.com
This device complies with Part 15 of the FCC rules subject to the following two conditions:
1) This device may not cause harmful interference
2) This device must accept all interference received, including intereference that may cause
undesired operation.
15.105 Information to the user statements:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
RF exposure warning statement
To comply with FCC RF exposure compliance requirements, a separation distance of at least 20 cm must
be maintained between the antenna of this device and all nearby persons
Changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.
6
version for the following label on the back of the
Description
) or PoE, through
DS1717-053A