Accessories; Recommended Cutting Equipment - Husqvarna T540i XP Manuel D'utilisation

Recommended cutting equipment

A specific chainsaw model has to be evaluated with the
cutting equipment to be recommended and fulfill the
requirements in ANSI B175.1-2012 (Internal Combustion
Engine-Powered Hand-Held Chainsaws - Safety and
Environmental Requirements) and Canadian Standards
CSA Z62.1-15 (Chainsaws) and CSA Z62.3-11 (R2016)
(Chainsaw kickback).
Chainsaw models Husqvarna T540i XP met the safety
requirements in ANSI B175.1-2012 and Canadian
Standards Association CSA Z62.1-15 (Chainsaws) and
CSA Z62.3-11 (R2016) (Chainsaw kickback), when
equipped with the below listed saw chain and guide bar
combination(s).
Note: Other chainsaw models may not meet the
kickback requirements when equipped with the listed
guide bar and saw chain combinations.
Guide bar
Length, in Chain pitch, in
12 0.325 mini
14
16
Filing equipment and filing angles
Using Husqvarna file gauge will give you the correct
filing angles. We recommend you to always use a
Husqvarna file gauge to restore the sharpness of the
5/32 in / 4.0
21
mm
Approved batteries for the product
Note: For maximum performance of the cutting
equipment, Husqvarna, recommends to use 1 of the
approved batteries that follow. It is possible to use other
28

Accessories

Gauge, in Max. nose ra-
dius
0.043 8T
60° 30°
We recommend only to use the listed guide bar and saw
chain combinations.
Kickback information
The guide bar nose radius is determined by either the
maximum number of teeth in the nose sprocket or the
corresponding maximum nose radius of a solid bar.
As we are listing the maximum guide bar nose radius,
you may use a guide bar with smaller nose radius than
in our list. For guide bars of the same length, all
sprocket-nose guide bars of the same pitch and having
the same number of sprocket teeth may be considered
to have equivalent kickback energy.
The following cutting equipment is approved for the
models Husqvarna T540i XP.
Saw chain
Type
Husqvarna
SP21G
saw chain. The part numbers are given in the table
below.
If you do not know which saw chain you have on your
product, turn to your servicing dealer.
0.025 in/
0°
0.65 mm
batteries but then the performance of the cutting
equipment decreases.
Length, drive Low kickback
links (no.)
51 Yes
59
64
5950046-01 5950047-01
1036 - 003 -