Measuring Functions - Bosch PLR 25 Notice Originale

24 | English
Selecting the Reference Level (see figures A–B)
Two different reference levels are available for measuring:
– The rear edge of the measuring tool (e.g. when placing
against a wall),
– The front measuring-tool edge (e.g. when measuring
onward from a table edge).
To change the reference level, press button 2 until the re-
quested reference level is indicated on the display. Each time
after switching on the measuring tool, the rear end of the
measuring tool is preset as the reference level.

Measuring Functions

Length Measurement
For length measurement, push button 6. The indicator for
length measurement appears in the display
Area Measurement
For area measurements, push button 5. The indicator for area
measurement appears in the display
Afterwards, measure the length and the width, one after anoth-
er, in the same manner as a length measurement. The laser
beam remains switched on between both measurements.
Volume Measurement
For volume measurements, push button 10. The indicator for
volume measurement appears in the display
Afterwards, measure the length, width and the height, one af-
ter another, in the same manner as for a length measurement.
The laser beam remains switched on between all three meas-
urements.
2 609 140 620 | (24.4.09)
Push the measuring button 9 once for
sighting and once more to take the meas-
urement.
The measured value is indicated at the
bottom in the display.
After taking the second measurement, the
area/surface is automatically calculated
and displayed. The last individual meas-
ured value is indicated at the bottom in
the display, while the final result is shown
at the top.
After taking the third measurement, the
volume is automatically calculated and dis-
played. The last individual measured value
is indicated at the bottom in the display,
while the final result is shown at the top.
.
.
.
Bosch Power Tools