Waeco MagicSafe MS620 Instructions De Montage Et De Service page 77

MS-620.book Seite 77 Dienstag, 18. Oktober 2005 3:04 15
MagicSafe MS620
➤
Press button 1 on the remote control once.
✓
You will hear an audible signal.
➤ Switch the ignition off and on again.
✓
You will hear another audible signal.
Selecting a software function
➤ Press button 1 on the remote control once, to activate software function 1.
➤
Press button 1 again to select the next software function or ...
Press button 2 on the remote control to select the previous software function.
✓
The alarm siren sounds a number of signals which correspond to the number of the
software function: e. g. one signal for software function 1, two signals for software
function 2, etc.
Selecting a setting
When you have selected the desired software function, you can assign a value to it (see
table in "Software functions" chapter on page 75 ):
➤
Press both buttons on the remote control together, to switch from one value to
another.
The status LED displays which value has been selected:
– LED glows: value 1 has been selected
– LED does not glow: value 2 has been selected
If you alter software function 3 ("Convenience function"), the current setting is increased
by one when both buttons are pressed; if both buttons are pressed when the value is 5,
the value skips back to 1.
✓
The status LED flashes to indicate the value selected, e. g. twice for a value of 2.
Acknowledging settings
➤
When you have altered the desired functions, switch the ignition off.
➤
Wait 10 s to save the setting, or ...
Switch the ignition on again before 10 s have elapsed, to make a new setting or to
check the setting.
10.4 Altering the PIN code
You can alter the PIN code and set it to a number from 1 to 9. To do this, proceed as fol-
lows:
➤
Select software function 9 ("Alter PIN code").
➤
Press both buttons on the remote control at the same time once.
➤
Press
– Button 1 on the remote control to increase the PIN code number by 1.
– Button 2 on the remote control to reduce the PIN code number by 1.
✓
The status LED displays the actual PIN code by flashing.
➤ Press both buttons on the remote control at the same time again, to save the selected
PIN number.
Programming MagicSafe
77