Waeco MagicSafe MS620 Instructions De Montage Et De Service page 69

MS-620.book Seite 69 Dienstag, 18. Oktober 2005 3:04 15
MagicSafe MS620
9.2 Activating MagicSafe
To activate the alarm system manually, proceed as follows:
➤
Switch the ignition off.
➤
Get out of the vehicle.
➤
Ensure that all doors and covers are closed.
➤ Press button 1 on the remote control.
✓
The alarm siren sounds a confirmation signal, if this function has been set to ON.
✓
The hazard lights flash once.
✓
The status LED starts flashing.
✓
If the alarm system is connected to the central locking, all doors and covers are
locked.
Silent activation and deactivation of the alarm system
You can switch the alarm so that the alarm siren does not sound any confirmation signal
when the alarm is activated.
Proceed as follows:
➤
Switch the ignition off.
➤
Get out of the vehicle.
➤
Ensure that all doors and covers are closed.
➤
Press both buttons on the remote control simultaneously to activate the alarm.
✓ The hazard lights flash once.
✓
The status LED starts flashing.
✓
If the alarm system is connected to the central locking, all doors and covers are
locked.
Activating the alarm system so that the vehicle can remain occupied
You can set the alarm system so that the shock sensor does not trigger an alarm, e. g. to
leave a pet in the vehicle.
Proceed as follows:
➤ Press button 1 on the remote control.
✓
The alarm siren sounds a signal, if this function has been set to ON.
✓
The hazard lights flash once.
➤
Press button 2 on the remote control within 3 seconds of pressing button 1.
✓
The alarm siren sounds a signal, if this function has been set to ON.
✓
The hazard lights flash once.
9.3 Deactivating MagicSafe
To deactivate the alarm system manually, proceed as follows:
➤
Press button 1 on the remote control.
✓
The alarm siren sounds two confirmation signals, if this function has been set to ON.
✓
The hazard lights flash twice.
✓
If the alarm system is connected to the central locking, all doors and covers are
unlocked.
Using MagicSafe
69