Waeco MagicSafe MS620 Instructions De Montage Et De Service page 56

MS-620.book Seite 56 Dienstag, 18. Oktober 2005 3:04 15
Electrical connections
Green/brown (P1.7)
If the indicators are positively charged (the cables to the indicators conduct +12 V, when
the indicators are activated):
➤
Connect this cable to +12 V.
If the indicators are negatively charged (the cables to the indicators conduct an earthed
charge, when the indicators are activated):
➤
Connect this cable to earth.
➤ Undo the soldered connections for the two diodes (fig. 8.12, page 7) in the black/
white and black/green cables and reverse their position (polarity) and resolder them.
Black/white and black/green (P1.8)
➤
Connect the black/white cable to the right indicator cable.
➤
Connect the black/green cable to the left indicator cable.
Red (P1.9)
➤
Connect this cable to a cable with a permanent +12 V charge (terminal +30).
Black (P1.10)
➤
Connect this cable to earth (terminal -31).
Brown (P1.11)
➤
Guide this cable through the splash-protection wall in the engine compartment.
➤ Connect this cable to the red alarm siren cable.
➤
Connect the negative pole of the alarm siren to earth.
Connecting the central locking
MagicSafe has a universal connection for central locking to enable standard central lock-
ing and engine-powered retrofitted central locking to be connected to the system.
You can find the cable colours and their functions in the following table:
Colour Plug
Blue/yellow P1.1
Blue/red P1.2
Red/black P1.3
Grey/yellow P1.4
Grey/red P1.5
Red/yellow P1.6
Connecting to the central locking
➤
Determine the switching function of the original central locking.
You require a circuit diagram of the central locking for this which you can obtain from
your vehicle dealership.
56
Function
Open normally closed
Open together
Open normally open
Closed normally closed
Close together
Close normally open
MagicSafe MS620