Waeco MagicSafe MS620 Instructions De Montage Et De Service page 70

MS-620.book Seite 70 Dienstag, 18. Oktober 2005 3:04 15
Using MagicSafe
➤
Get into the vehicle within 30 s.
Otherwise MagicSafe assumes that you did not wish to deactivate it and will activate
itself automatically (software function 5, "Reactivate" set to "ON").
The doors may also be locked again (software function 6 "Locking on reactivation"
set to "ON").
Deactivating MagicSafe silently
You can deactivate MagicSafe without the alarm siren giving a confirmation signal.
Proceed as follows:
➤
Press both buttons on the remote control simultaneously to deactivate the alarm.
✓
If the alarm system is connected to the central locking, all doors and covers are
unlocked.
✓
The hazard lights flash twice.
Deactivating MagicSafe when the alarm has been triggered
You can deactivate MagicSafe in two stages.
Proceed as follows:
➤
Press button 1 on the remote control.
✓
The alarm is deactivated but the doors remain locked and the alarm system remains
active.
➤
Press button 1 on the remote control again.
✓ The alarm is deactivated and the doors are unlocked.
Deactivating MagicSafe without the remote control
If you have misplaced the remote control or the batteries are empty or the remote control
is damaged, you can deactivate the alarm system with your PIN code.
To do this, proceed as follows:
➤
Switch the ignition on and off twice.
➤
Switch on the ignition again within 7 s.
✓
The status LED flashes quickly for 3 s.
✓
Afterwards the status LED flashes once per second.
➤
Count how often the status LED flashes and switch off the ignition when the number
of flashes corresponds to your PIN code.
✓
The alarm system is deactivated.
If you switch on the ignition too late or too early the PIN code is incorrect and
the alarm system remains activated.
If the PIN code is entered incorrectly twice, the alarm system blocks further
attempts for the next three minutes. This is indicated by the status LED which
flashes at double speed.
The PIN code set at the plant is 1.
You can set your own PIN code to a number from 1 to 9 (see "Altering the
PIN code" chapter on page 77).
70
MagicSafe MS620