Waeco MagicSafe MS620 Instructions De Montage Et De Service page 71

MS-620.book Seite 71 Dienstag, 18. Oktober 2005 3:04 15
MagicSafe MS620
9.4 Setting the service mode
You can set the alarm to service mode if, for example the vehicle is to be handed over
for repairs or inspection. In service mode, all settings for the alarm system remain stored,
even if the battery is disconnected.
To do this, proceed as follows:
➤ Deactivate the alarm system.
➤
Switch the ignition on.
➤
Press button 2 on the remote control and hold it down for 3 s.
✓
The hazard lights flash three times.
✓
The status LED glows constantly.
Switching off service mode
➤
Switch the ignition on.
➤
Press button 2 on the remote control.
✓ The alarm siren sounds three times.
✓
The service mode is switched off.
9.5 Using the panic mode
The alarm system has a panic mode. You can trigger the alarm via remote control, if you
are attacked to scare off the attacker. The ignition must be switched off for this function.
To activate the panic mode, proceed as follows:
➤
Press button 1 on the remote control and hold it down for 3 s.
✓ The alarm siren is switched on.
✓
The hazard lights flash.
✓
The vehicle remains operational enabling you to drive away.
Switching off the panic mode
➤
Press button 1 on the remote control.
✓
The panic mode is switched off.
9.6 Using the vehicle search function
You can use MagicSafe to indicate the location of your vehicle optically and acoustically.
The ignition must be switched off for this and MagicSafe must be activated.
Proceed as follows:
➤ Press button 2 on the remote control.
✓
The alarm siren sounds a signal.
✓
The hazard lights flash six times.
Using MagicSafe
71