Displayed Centrifugation Parameters After Switching On The Device - Hettich EBA 280 Mode D'emploi

EN
20.6

Displayed centrifugation parameters after switching on the device

It can be set whether the centrifugation parameters of the last used program or of program 1 should be displayed
after switching on the device.
With the rotor at a standstill, this can be set as follows:
The procedure can be aborted at any time by pressing the
 Press and hold the button for eight
seconds.

 Press the key until the following is
displayed:

 Press the key.
START
PULSE

 Press the key until one of the following is
displayed:
Start Pr : Displayed program after
switching on.
First : Program 1.
Last : Last used program.

 Set First or Last with the keys.

 Press the key to save the setting.
START
PULSE

 Press the key once to exit the "
STOP
Settings"
OPEN
menu or press twice to exit the "
MACHINE MENU ".
74/166
STOP
key. In this case, the settings are not stored.
OPEN
PROG RPM t/min:s
PROG RPM t/min:s
PROG RPM t/min:s
PROG RPM t/min:s
PROG RPM t/min:s
PROG RPM t/min:s
PROG RPM t/min:s
PROG RPM t/min:s
Rev. 03
PROG RPM t/min:s
PROG RPM t/min:s
PROG RPM t/min:s
Example:
PROG RPM t/min:s
AB1101DEENFRIT