Make sure that the adjusting mechanism of the seat is not blocked. The cables for the seat air bag and seat belt tensioning
device may not be damaged.
6.3 CONNECTION
In a vehicle:
Connect the connecting cable of the seat cushion (Position 4 in the overview) to the vehicle connecting cable (Position 9 in the overview).
Insert the vehicle plug into the on-board socket of your vehicle.
With some vehicle types, the on-board socket can only be used after the ignition has been switched on.
On a seat:
Connect the connecting cable of the seat cushion (Position 4 in the overview) to the power supply (Position 10 in the overview). Plug the
power supply into a socket.
6.4 OPERATION
Cooling function:
Pressing the cooling switch (Position 11 in the overview) switches the
cooling function of the climate-regulating seat cushion on, at Stage III.
Pressing the switch again will activate the following functions, one after
another, Figure 2:
Heating function:
Pressing the heating switch (Position 13 in the overview) switches the
heating function of the climate-regulating seat cushion on, at Stage III.
Pressing the switch again will activate the following functions, one after
another, Figure 3:
Simultaneous operation of the cooling and heating functions is not possible. When the mode is changed, the previously selec-
ted function is deactivated.
7. MAINTENANCE AND CARE
7.1 CLEANING
Clean the climate-regulating seat cushion with a dry cloth only. Do not use aggressive cleaning agents or solvents. Never allow liquids to
get into the seat cushion. Allow the seat cushion to air dry fully before putting it back into operation.
7.2 REPLACING THE FUSE
Rotate the tip (Position 16 in Figure 4) of the 12 V plug (Position 14 in Figure 4) anti-clockwise until it comes away from the plug and
then remove. The fuse (Position 15 in Figure 4) is exposed and can be removed from the plug. Replace the fuse with another of the same
strength and screw the tip back into the plug, Figure 4.
Check the plug, the cable and the seat cushion for damages.
Figure 4: Fuse in 12 V plug
Stage III
Stage II
cooling
cooling
Figure 2: Cooling function
Stage III
Stage II
heating
heating
Figure 3: Heating function
Type: Micro-fuse 5 x 20 mm, F, 4 A, 250 V
Stage I
OFF
cooling
Stage I
OFF
heating
7