Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
8. ATTACHING THE LID HANDLE
Parts Required:
2
x
Lid Handle Bezel (#12)
1
x
Lid Handle (#13)
Installation:
•
Remove the pre-installed screws from the lid handle. From inside the
barrel lid, insert one screw so that it protrudes to the outside. Add a
bezel on the screw, then hand-tighten the screw (from the inside) into
the lid handle. Repeat same installation for other end of lid handle.
9. SECURING THE LID STOPPER
Parts Required:
Lid Stopper (#9)
1
x
Installation:
•
Secure the lid stopper onto the top of the main barrel using the pre-
installed screw on the top of the main barrel.
10. MOUNTING THE SIDE SHELF HANDLE, SERVING TRAY
Parts Required:
Serving Tray Handle (#15)
2
x
Serving Tray (#16)
1
x
1
x
Side Shelf Handle (#17)
Installation:
•
Remove the four pre-installed screws from the side of the main barrel.
Mount the side shelf handle onto the main barrel using four screws
previously removed.
•
Mount serving tray handles to serving tray using the two pre-installed
screws on each handle. Place the serving tray onto the side shelf
handle. It will rest directly on the frame of the side shelf handle.
IMPORTANT: Avoid using the side shelf handle to move or lift the
grill. The weight of the unit will cause the side shelf handle to bend
or break, which is not covered by warranty.
9
8
13
12
12
9
9
10
15
17
15
16
Publicité
Chapitres
Table des Matières
