Installation Considerations - Hansgrohe E 04228 0 Série Instructions De Montage / Mode D'emploi / Garantie

Technical Information / Données techniques / Datos tecnicos
Recommended water
pressure
Max. water pressure
Recommended hot
water temp.
Max. hot water temp
Flow rate
*Please know and follow all applicable local plumbing codes when setting the temperature on the water heater.
* Vous devez connaître et respecter tous les codes de plomberie locaux applicables pour le réglage de la température du
chauffe-eau.
*Debe conocer y cumplir todos los códigos locales aplicables para ajustar la temperatura del calentador de agua.

Installation Considerations

• For best results, Hansgrohe recommends that
this unit be installed by a licensed, profes-
sional plumber.
• Please read over these instructions thoroughly
before beginning installation. Make sure that
you have all tools and supplies needed to
complete the installation.
• This trim is for use with iBox Universal Plus
model 01850181 (not included).
• To prevent scald injury, the maximum output
temperature of the shower valve must be
no higher than 120°F. In Massachusetts,
the maximum output temperature can be no
higher than 112° F.
• Adjust the rotational limit stop (see page 18)
during installation. Further adjustments may
be necessary due to seasonal water tempera-
ture changes.
Pression d'eau recommandée Presión recomendada
Pression d'eau maximum
Température recommandée
d'eau chaude
Température maximum d'eau
chaude
Capacité nominale
en servicio
Presión en servicio max.
Temperatura recomen-
dada del agua caliente
Temperatura del agua
caliente max.
Caudal máximo
• Do not install a shut-off device on either outlet
of this valve. Use of such a device can defeat
the ability of the valve to balance the hot and
cold water pressures.
• The pressure balance trim is suitable for a one-
function installation, such as a single shower-
head or handshower.
• The pressure balance trim may be used in a
tub/shower application using a diverter tub
spout.
• Keep this booklet and the receipt (or other
proof of date and place of purchase) for
this product in a safe place. The receipt is
required should it be necessary to request
warranty parts.
15 - 75 psi
145 psi
120� - 140� F*
176�F*
4.5 gpm @ 44
psi
3