Hansgrohe E 04228 0 Série Instructions De Montage / Mode D'emploi / Garantie page 16

4 mm
Ø
1
Ø
16
1
2
2
3
2
English
Reverse the cartridge
If the valve opens through hot, reverse the
cartridge.
Close the stops using a 4 mm Allen
wrench, or turn the water off at the
main (1).
Unscrew the nut (2).
Use the following procedure to
remove the cartridge.
Do not attempt to pry the cartridge
from the function block by using
a screwdriver, or damage to the
cartridge will result.
Place the handle on the cartridge stem.
Turn the handle counter-clockwise approximately
¼ turn after hitting the stop.
Lift the cartridge out (1).
Turn the cartridge 180°, so that the "hot side"
marking is on the right (2).
Install the cartridge (3)
Install the nut (4).
Continue the installation.
4