Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
7.
Remove the blades. Clean and apply oil to the tines
and tine shafts (3g) to prevent rusting. Mount the
tines onto the tine shafts (3g).
8. Coat the wheel axles lightly with oil. Oil the throttle
cables and all visible moving parts. Do not remove
the engine cover.
9.
Storage with retracted handlebars:
Loosen the special screw (13d) which secures the up-
per handlebar (6) with the lower steering column (7).
Gently lower the upper handlebar (6) downwards. Make
sure that the control cables are not pinched or kinked.
Tighten the special screw (13d).
10. Store your tiller in upright position in a clean, dry
building that has good ventilation.
m ATTENTION! Do not store tiller with fuel in a non-ven-
tilated area where fuel fumes may reach flame, sparks,
pilot lights or any ignition sources. Use only approved
fuel containers.
13. Transport
Transportation by pushing
Install the wheels as described in the chapter "Plow-
ing function".
Start the engine and gently accelerate. Machine moves
slowly forwards.
14. Disposal and recycling
The equipment is supplied in packaging to prevent it from
being damaged in transit. The raw materials in this pack-
aging can be reused or recycled.
The equipment and its accessories are made of various
types of material, such as metal and plastic. Defective
components must be disposed of as special waste. Ask
your dealer or your local council.
15. Troubleshooting
m ATTENTION! Before carrying out any tests recom-
mended in the following table, always turn off the
unit and disconnect the spark plug, unless the oper-
ation of the unit is expressly required.
If all possible causes have been checked but the
problem has not been solved, please contact an au-
thorized service center. If a problem does not appear
in this table, please contact an authorized service
center.
32
GB
www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
Publicité
Table des Matières
