Panasonic CS-VE9NKE Guide Rapide page 9

TO MONITOR HUMAN PRESENCE & ACTIVITY
10
• The human activity sensor will scan for the heat source
and movement in the room.
• The unit will determine the heat source & movement
hotspot, and automatically adjust horizontal airfl ow
direction louver fi x at predetermined position.
• When manual AIR SWING
selected, AUTO COMFORT operation will be cancel.
TO PURIFY THE AIR
11
• Removes/deactivates harmful micro-organisms such as
viruses, bacteria, etc.
• nanoe-G starts automatically when the unit switched on.
TO USE MAINTENANCE HEATING
12
• Maintain indoor temperature at +8/10ºC. Fan switches to
high fan speed automatically.
• This operation overwrite the operation mode and could be
cancelled by pressing AUTO, HEAT, COOL or DRY mode.
• Deice operation at outdoor unit will result in
sudden cold air from indoor unit. Eliminate
cold air with heat mode.
INFO
13
• Press during HEAT or AUTO mode to retrieve level of heat
stored in heat absorbing device; HEAT CHARGE level 1
(min.) to 4 (max.). "--" will be displayed during COOL, DRY
or NANOE-G mode.
• Press to retrieve error code when the unit stops and the
timer indicator blinks.
If the signal transmission is failed, (PRESS AGAIN).
TO TURN OFF THE UNIT AFTER ASLEEP
14
0.5 1 2 3
SLEEP
• When used together with the timer, sleep operation has a
priority.
PRESS TO RESTORE THE INDOOR UNIT
15
SETTING
• To restore the remote control's default setting, remove the
batteries.
F568728_YB0512-1062.indb 9 F568728_YB0512-1062.indb 9
or FAN SPEED is
NANOE-G
+ 8/10°C
10°C
8°C
5 7 9hr Cancel
TO SET THE TIMER
16
• 2 sets of ON and OFF timers are available to turn ON or
OFF the unit at different preset time.
• Complete below procedures to set each timer:
Cancel
Cancel
Select ON or OFF timer
• Example of application at living room:
Morning: ON at 07:00 (Wake up)
OFF at 08:00 (Out for work)
Evening: ON at 17:00 (Back home)
OFF at 22:00 (Sleep)
• To cancel ON or OFF timer, press
select respective or then press
• If timer is cancelled manually or due to power failure,
you can restore the timer again by pressing
to select respective
• Upcoming timer will be displayed and will be activated
in sequence.
• When ON Timer is set, the unit may start earlier (up to 15
minutes at COOL mode, up to 40 minutes at HEAT mode)
before the actual set time in order to achieve the desired
temperature on time.
• Timer operation is based on the clock set in the remote
control and repeats daily once set. For clock setting,
please refer to Remote Control Preparation on the back
cover.
TIMER
Set the
Confi rm
time
or to
.
or
or then press .
6/11/2012 9:43:31 AM 6/11/2012 9:43:31 AM
9