Connecting Wires To Terminals - Kenwood KDC-C519FM Mode D'emploi

Connecting Wires to Terminals

Display unit
REP
C D A U T O C H A N G E R C O N T R O L L E R
T R A C K RDM
DISC
FREQ FREQ
LEVEL LEVEL
3 8
/
M . R D M M . R D M D . R E P D . R E P D . S C N S C N M H z M H z
T R A C K D I S C
4 ¢ - +
PWR
Control input
FM modulator unit
2WARNING
To prevent fire when the ignition wire (Red) or battery wire
(Yellow) is short-circuited by coming into contact with the
vehicle chassis (ground), only connect the power supply after
making the fuse box connections.
2CAUTION
Be sure to press the reset button after installation.
Control output
Changer connection wire 4
CD auto - changer input
FM/AM antenna input
FM/AM antenna output
+
Ignition wire (Red)
+
Battery wire (Yellow)
-
Ground wire (Black) (To car chassis)
— 17 —
CD auto-changer
9
Antenna plug
for automobile
Car stereo
with FM tuner
8
Ignition key
switch
ACC
Car fuse box
Battery
NOTE
Do not install an antenna of radio equipment or distribute the
antenna wire near the changer output wire, for this could
cause malfunction with this unit.
Output