Siemens PolyCool Superheat - CPS40 Manuel D'installation Et D'utilisation page 40

Picture Function
16 Manipulated EIV
opening degree
17 EIV actual
position feed-
back to the
manipulated
opening
18 Actual value
display
40 / 120
Siemens
Building Technologies
Simulation mode / SIMU
(Continue with <OK> / picture 15)
Parameter Code
Setpoint * MAN EIV 0...10 V /
DC 0...10 V
signal
DC 0...10 V MAN EIV
signal EIV
0...100 %
opening
Evaporation TO
temperature
Suction gas TOH
temperature
Continuously press <ESC> to exit
* Caution! At your own risk!
1) In the simulation mode, the monitoring functions are deactivated
if not enabled via D1. Therefore, your plant could be seriously
damaged.
2) In the simulation mode, the monitoring functions can be deac-
tivated on purpose (through D1). This allows the plant to be
manually operated for about 15 minutes.
Superheat - CPS40
Commissioning
Adjustable Settings
range Default
0.0 V
0.1 V
- -
-
-
Procedure
Set parameter
/ value with +/-
Confirm with
<OK>
Back to regu-
lation mode
with <ESC>
CE1U3372xx
2018-11-09