Cleaning And Maintenance - Bosch MSM6S Série Mode D'emploi

Notes:
– The inserts should not be used for
cutting very hard foods (Parmesan
cheese, chocolate).
– The inserts are only partly suitable for
processing fibrous foods (leek, celery,
rhubarb).
X Fig. D
1. Fit the desired insert into the
carrier disc.
2. Place the container on a stable, smooth
and clean work surface. Grasp the
carrier disc by the recessed grips and
insert.
3. Place the gear attachment on the
container (.) and rotate anticlockwise
until it clicks into position.
4. Place the base unit on the gear
attachment and press until it clicks into
position.
5. Set the desired speed with the speed
control. Plug the mains plug into the
mains.
6. Hold the base unit. Press the On
button Ã. The appliance remains
switched on as long as the button is
pressed.
7. Add the food to be processed to the
feed chute. Cut up very large pieces
beforehand. Only use the pusher
provided to add food.
8. Release the button once processing is
finished or the processed food reaches
the underside of the carrier disc. Wait
until the drive comes to a standstill.
Disconnect the mains plug.
9. Hold down both release buttons and
remove the base unit.
10. Rotate the gear attachment clockwise
and remove.
11. Grasp the carrier disc by the recessed
grips and remove.
12. Empty the container.
■ Clean all parts immediately after use.
X "Cleaning and maintenance" see
page 11
Cleaning and maintenance

Cleaning and maintenance

The attachments and accessories used
must be thoroughly cleaned after each use.
W Risk of injury
Do not touch the blades of the universal
cutter / cutting attachment with bare hands.
To clean, only grasp by the plastic and use
a brush.
Caution!
– Do not use any cleaning agents
containing alcohol or spirits.
– Do not use any sharp, pointed or
metal objects.
– Do not use abrasive cloths or cleaning
agents.
– Never immerse the gear attachment in
liquids or hold under running water and
do not clean in the dishwasher.
Please note:
– Do not wedge plastic parts in the
dishwasher as they could become
deformed.
– When processing food such as red
cabbage or carrots, plastic parts may
become discoloured. This can be
removed with a few drops of cooking oil.
In Fig. E you will find a summary of how to
clean the individual parts.
■ Wipe the gear attachment with a soft,
damp cloth and dry off.
■ Turn over the carrier disc to press out
the inserts (X Fig. B).
■ The container, universal blade, carrier
disc and cutting attachments are
dishwasher­safe.
Subject to change without notice.
en
11