Cutting Attachments - Bosch MSM6S Série Mode D'emploi

en Universal blade
Universal blade
For cutting meat, hard cheese, onions, herbs,
garlic, fruit, vegetables, nuts and almonds.
Use
Always observe the maximum quantities
and processing times. X Table F
W Risk of injury!
– Do not touch the blades of the universal
cutter with bare hands. Grasp the
universal blade by the plastic only.
– Never reach into the feed chute.
Only use the pusher provided when
adding food.
X Fig. C
1. Place the container on a stable, smooth
and clean work surface. Insert universal
blade.
Important: The blade must be positioned
straight in the container.
2. Add food.
3. Place the gear attachment on the
container (.) and rotate anticlockwise
until it clicks into position. Insert the
pusher in the feed chute.
Note: If fitting the lid is a bit stiff, turn the
three­piece coupling on the underside of the
attachment slightly and try again.
4. Place the base unit on the gear
attachment and press until it clicks into
position.
5. Plug the mains plug into the mains.
6. Hold the base unit and multifunction
accessory. Press the Turbo button Â.
The appliance remains switched on as
long as the button is pressed.
7. Process the food with the universal
blade.
8. Release the button when the desired
consistency is reached. Wait until
the drive comes to a standstill.
Disconnect the mains plug.
9. Hold down both release buttons and
remove the base unit.
10. Rotate the gear attachment clockwise
and remove.
11. Take out the blade.
12. Empty the container.
10
■ Clean all parts immediately after use.
X "Cleaning and maintenance" see
page 11
Add the extra ingredients:
■ Release the button. Wait until the
appliance comes to a standstill.
■ Remove the pusher and add ingredients
through the feed tube.
■ Replace the pusher and continue
working.

Cutting attachments

Slicing insert – coarse
For cutting fruit and vegetables into thick
slices (e.g. for potatoes au gratin or fried
potatoes, for cutting carrots and cucumber).
Slicing insert – fine
For cutting fruit and vegetables into thin
slices (e.g. for cucumber salad or potatoes
and carrots for vegetable crisps).
Shredding insert
For shredding cheese, apples and carrots
for raw food salads.
Grating insert
For grating potatoes for dumplings or potato
pancakes. For grating carrots.
Use
W Risk of injury!
– Never grasp the sharp blades or
edges of the cutter attachments. Grip
attachments by the plastic part only.
– Never reach into the feed chute. Only
use the pusher provided when adding
food.
Always observe the maximum quantities
and processing times. X Table F
Caution!
Finish processing and empty the container
before the processed food reaches the
underside of the carrier disc.
Important: Note the shape and location of
the inserts when inserting in the carrier disc
(X Fig. B). Take hold of carrier disc by the
designated recessed grips only.