Take Measurement; Diagnostic Functions - Beurer BF 600 Mode D'emploi

8. Take measurement

Place the scale on an even, hard surface; a hard surface is crucial to accurate measurements.

8.1 Diagnostic functions

Step onto the scale with bare feet and ensure that you are standing still with
equal weight distribution and with both legs on the electrodes
Note: The measurement result will be incorrect if the measurement is taken
with socks on.
The scale begins to take measurements straight away.
First, the weight is displayed.
During the BIA analysis, "
If a user was assigned, P-01 – P-08 is displayed and all of the following values will be
saved.
1. BMI
2. Body fat in %
3. Body water in %
4. Muscle percentage in %
5. Bone mineral amount in kg
6. Basal metabolic rate in kcal (BMR)
7. Active metabolic rate in kcal (AMR)
Note: If the user is not recognised, then the user assignment (e.g. P-01) is missing and only the
weight can be displayed. The measured values will not be saved.
This happens if your measured weight differs from the previous measurement by ± 3 kg or if another
user has similar values (± 3 kg) to yours. In this case, repeat the measurement by turning on the
scale and pressing the " " button to select your user memory (P-01 – P-08). Repeat the measure-
ment.
8.2 Weight
Step onto the scale wearing shoes and ensure that you are standing still with
equal weight distribution and with both legs on the scale. The scale begins to
take measurements straight away.
First, the weight is displayed.
" " will briefly be displayed on the LCD. A BIA analysis is not possible.
If a user was assigned, "P-01", for example, will be displayed and the weight will
be saved.
Note: If the user is not recognised, then the user assignment (e.g. P-01) is missing and only the
weight can be displayed. The measured values will not be saved.
This happens if your measured weight differs from the previous measurement by ± 3 kg or if another
user has similar values (± 3 kg) to yours. In this case, repeat the measurement by turning on the
scale and pressing the " " button to select your user memory (P-01 – P-08). Repeat the measure-
ment.
" is displayed.
18