Troubleshooting - Sony VPL-ES1 Mode D'emploi

Troubleshooting

If the projector appears to be operating erratically, try to diagnose and correct the problem
using the following instructions. If the problem persists, consult with qualified Sony personnel.
Power
Symptom
The power is not turned on. • The power has been turned off and on with the I / 1 key at a short
Both the LAMP/COVER
and TEMP/FAN indicators
light up.
The powered tilt adjuster
and the lens protector do
not close.
The powered tilt adjuster
and the lens protector do
not work at all.
Picture
Symptom
No picture.
The picture is noisy.
42
GB
Troubleshooting
Cause and Remedy
interval.
c Wait for about 90 seconds before turning on the power
(see page 27).
• The lamp cover is detached.
c Close the lamp cover securely (see page 39).
• The electrical system breaks down.
c Consult with qualified Sony personnel.
• The AC power cord is unplugged with the power of the projector
turned on.
c Connect the power cord plug to the AC outlet again, then turn
off the power of the projector.
• The electrical system breaks down.
c Consult with qualified Sony personnel. If it is necessary to use
the projector in case of emergency, use it in the emergency mode
(see page 46).
Cause and Remedy
• Cable is disconnected or the connections are wrong.
c Check that the proper connections have been made
(see page 17).
• Input selection is incorrect.
c Select the input source correctly using the INPUT key
(see page 24).
• The computer signal is not set to output to an external monitor or
set to output both to an external monitor and a LCD monitor of a
computer.
c Set the computer signal to output only to an external monitor
(see page 17).
c Depending on the type of your computer, for example a
notebook, or an all-in-one LCD type, you may have to switch
the computer to output to the projector by pressing certain keys
or by changing your computer's settings. (See page 24)
For details, refer to the computer's operating instructions
supplied with your computer.
• Noise may appear on the background depending on the
combination of the numbers of dot input from the connector and
numbers of pixel on the LCD panel.
c Change the desktop pattern on the connected computer.