Troubleshooting; Remote Commander - Sony VPL-VW11HT Mode D'emploi

Troubleshooting

Troubleshooting
If the projector appears to be operating erratically, try to diagnose and correct the problem, using the following
guide. If the problem still persists, consult with qualified Sony personnel.
Power
Symptom
The power is not turned on.
Image
Symptom
No picture.
The picture is noisy.
On-screen display does not
appear.

Remote Commander

Symptom
The Remote Commander
does not work.
36
(GB)
Cause
The power has been turned off and on
with the I / 1 key at a short interval.
The lamp cover is detached.
The air filter is detached.
Cause
Cable is disconnected or not connected
properly.
Invalid input setting.
Input selection is incorrect.
Picture is cut off.
The computer output signals are not set
to output from an external monitor.
The computer signal is set to output to
both the LCD of the computer and
external monitor.
If you input computer signals, some
noise will appear in the background on
certain screens depending on the
number of dots in the input signals and
LCD pixels.
STATUS in the SET SETTING menu has
been set to OFF.
Cause
The Remote Commander batteries are
dead.
The remote control cable is not
connected to the CONTROL S IN
connector (projector) or CONTROL S
OUT (Remote Commander).
The front/rear remote control detector is
near the fluorescent lamp.
The Remote Commander is used as
wired without batteries.
Remedy
Wait for about 120 seconds before turning on the
power (see page 20 (GB)) .
Close the lamp cover securely (see page
34 (GB)) .
Close the air filter securely (see page
35(GB)) .
Remedy
Check that the proper connections have been
made (see pages 15 (GB) and 16 (GB)) .
Set the INPUT-A/B setting according to the input
signal.
Select the input source correctly using the INPUT
key (see page 18 (GB)) .
Press the MUTING PIC key to release the muting
function (see page 18 (GB)) .
Set the computer signal to output to external
monitor (see page 16 (GB)) .
Set the computer signal to output only to external
monitor (see page 16 (GB)) .
Change the desktop pattern on the connected
computer.
Set STATUS in the SET SETTING menu to ON
(see page 27 (GB)) .
Remedy
Replace with new batteries (see page 14 (GB)) .
Connect the remote control cable to both the
projector and Remote Commander, or disconnect
the cable. (see page 13 (GB)) .
Change the setting of SIRCS RECEIVER in the
SET SETTING menu (see page 27 (GB)) .
Install batteries (see page 14 (GB)) .