Fitting The Carrying Cord; Inserting And Changing The Battery - Leica PINMASTER Notice D'utilisation

fIttIng the carryIng cord

Push the smaller loop through the eyelet (4) on the
housing of the LEIca PINmaSTEr.
Then, thread the longer loop through the smaller
loop and pull it tight so that the carrying cord is
securely attached to the eyelet.
open
close

InsertIng and changIng the battery

The LEIca PINmaSTEr is supplied with power by one
3 Volt lithium cell (e.g. Duracell DL cr 2, Ucar cr 2,
Varta cr 2, or other cr 2
types).
1. Open the battery compartment (7) cover (6) by
turning it anticlockwise.
2. Insert the battery with its positive contact facing
forwards (as marked in the battery compartment).
3. close the cover again by turning it clockwise.
20