Bosch Indego M 700 Notice Originale page 31

Problem Possible Cause
Charging pins corroded
Battery not fitted, incorrectly fitted or in-
correct battery for mower
Mower out of peri- Perimeter wire on a slope
meter wire
Obstacle near perimeter wire
Parts of the lawn area Mower requires more cuts to finish garden Allow mower to run for 3 full cuts to cover whole lawn
left uncut
Time slot not long enough for garden size
Distance between perimeter wires too
small
Rough mowing conditions
Grass too long
Slopes in garden too steep
Mower gets stuck in Objects/obstacles not marked out
garden
Newly laid turf
Mower unintentionally Objects/obstacles below 5 cm not marked
cuts flowers, etc. or out
runs over certain
obstacles
Mower does not ap- LogiCut system depends on the garden
pear to cut logically conditions. Mower does not necessarily
have to continue in the next uncut area.
Mower does not always go in a straight line
when travelling between areas
Mower frequently does not find right posi-
tion or turns on the spot
Wire crossed while marking an object
Mower runs in random paths in an addi-
tional lawn without docking station.
Perimeter wire keeps Wire is not taut between pegs
being cut
Distance between pegs is more than 75 cm
Bosch Power Tools
Corrective Measure
Clean the charging pins.
Insert battery correctly (see figure L). Use the appropri-
ate Bosch battery.
Leave 30 cm between the perimeter wire and the slope.
Remove obstacle.
area.
Increase mowing time slot or:
– use "Bosch AUTO" calendar function (with Indego M
700)
– use Bosch "SmartMowing" functionality (with In-
dego M+ 700)
Increase distance between the perimeter wires to a min-
imum of 75 cm.
Select "uneven ground/low sensitivity" option from menu
item "lawn condition/bump sensor".
Flatten garden/remove/bumps/mark out unsuitable
areas with the perimeter wire – Please follow the instruc-
tions in the Installation Guide.
Select "uneven ground/low sensitivity" option from menu
item "lawn condition/bump sensor".
Ensure mower only operates on slopes of 15 degrees or
less and full garden is not on a slope.
Use the perimeter wire to mark off obstacles where the
mower often gets stuck.
Allow a few weeks for the soil to settle before using the
mower.
Change setting in menu item "lawn condition / bump
sensor" to low sensitivity / uneven.
After watering, wait as long as possible until you start the
mower.
Mark obstacle using perimeter wire leaving 30 cm from
object or remove objects/obstacles.
Further information can be found on the Installation
Guide.
If behaviour re-occurs often, remap garden.
No corrective action needed.
Change wire ID.
Follow instructions in the Installation Guide.
Normal behaviour. The LogiCut system only works in
areas with docking station.
Make wire taut and ensure distance between pegs is
maximum 75 cm. Follow instructions in the Installation
Guide. Use the wire connectors to repair the cut.
F 016 L81 885 | (23.10.2019)
English | 31