Descaling The Appliance; Cleaning Surfaces; Remedying Problems Yourself - SEVERIN KA4810 Mode D'emploi

7.4 Descaling the appliance

1. Make sure there is no filter with coffee grounds in the appliance and the
coffee jug is clean.
4 5 6
2. Remove the coffee jug .
4 5 6
3. Fill the coffee jug up to the "10" mark with cold tap water.
4 5 6
4. Pour the water into the water tank
5. Pour 80 ml of vinegar into the water tank
6. Place the coffee jug on the hotplate
4 5 6
7. Plug the power plug into the socket.
7 8 9
 The appliance switches on automatically.
8. Press the "GRIND OFF" button.
 The LED next to the "GRIND OFF" button comes on, indicating that
the grinder is switched off.
9. Press the " " button.
 The LED next to the " " button lights up. The entire water/vinegar
solution runs through the appliance. Wait until all of the water/vine-
gar solution has run through and the LED has gone out.
10. Press the " " button to switch off the hotplate
11. Run water through the appliance, ►"7.3 Running water through the
appliance" on page 30, to remove the remains of the water/vinegar
solution.

7.5 Cleaning surfaces

Clean the surfaces of the appliance with a soft, lint-free cloth.
.
12 13 14
.
12 13 14
.
6 7 8
.
6 7 8
8 Troubleshooting

8.1 Remedying problems yourself

WARNING!
Risk of injury! The appliance does not contain any
parts that you can repair yourself.
– Never attempt to operate a defective appliance.
– Never attempt to repair the appliance by
yourself. If your appliance is defective, contact
our customer service department (see "Service
Centres" on page 192).
Before contacting our customer service, check with the aid of the table below
whether you can remedy the problem yourself.
Problem Cause
The appliance The appliance is
will not switch not connected
on. to the power
supply.
Coffee does Coffee jug not
not flow out of
placed correctly
the outlet (drip under outlet.
stop).
Remedy
Plug the power plug into a socket
outlet with earthing contact.
Check that the coffee jug is placed
correctly on the hotplate and that is
presses up the valve in the outlet.
GB
31