Remote Control - Denon Professional DN-F350 Guide D'utilisation

Remote Control

Battery Usage
Important: Before using the remote control for the
first time, pull the insulation sheet out from the
battery compartment.
To replace the battery:
1. On the back of the remote control, put a
paperclip into the door release hole and then
slide the door release open.
2. Pull out the old lithium battery from the battery
case and insert a new one. Place the battery so
that the positive (+) side faces upward.
3. Place the battery case carefully into the
compartment so the edges are in the grooves
and then slide the battery case to its original
position.
Important: Misuse of the lithium battery can result in heat build-up, ignition, or rupture. Bear in mind
the following points when using or replacing batteries:
•
The supplied battery is for testing the functionality of the remote controller.
•
Use a 3V CR2032 lithium battery.
•
Never recharge the battery. Do not handle the battery roughly or disassemble the battery.
•
When replacing the battery, place it with its polarities (+ and −) facing the correct directions.
•
Do not leave the battery in a place subject to high temperature or direct sunlight.
•
Keep the battery in a place beyond the reach of infants or children. If a battery is swallowed,
consult a physician immediately.
•
If electrolyte has leaked, discard the battery immediately. Be careful when handling it as the
electrolyte can burn your skin or clothes. If the electrolyte touches your skin or clothes, immediately
wash with tap water and consult a physician.
•
Before discarding a battery, insulate it with tape, etc. and dispose of it in a place without fire, by
following the directions or regulations laid down by the local authorities in the area of its disposal.
Operating Range
Point the remote control at the IR sensor when operating it.
Note: If the remote control sensor is exposed to direct sunlight, strong artificial light (like from an
interverter-type fluorescent lamp), or infrared light, the unit or remote control may not function properly.
8
DOOR RELEASE
DOOR RELEASE
OPEN
+
1
2
DOOR RELEASE
OPEN
3