Additional Functions; Updating The Firmware - Denon Professional DN-F350 Guide D'utilisation

Additional Functions

Menu Settings
To access the Menu settings, press and hold the Master Volume dial (or press and hold the Display button on the remote). Turn the Master Volume
dial or use the < and > buttons on the remote to navigate through the menu. Press and release the Master Volume dial to select an option or press the
Play/Pause button on the remote. Press and hold the Master Volume dial or press the Stop button on the remote to return to the previous Menu
option, exit out of the menu, or wait a few seconds and the unit will automatically exit out of the Menu settings. The Menu settings seen are:
•
Line In/Mic (Sets the input signal to be either line-level or mic-level)
•
Paging (sets the "ducking" for the microphone input on or off. When set to ON, the audio source volume will be reduced to the background
when the microphone is used. When set to OFF, the audio source will be heard at its set volume when the microphone is used.
•
System Version (displays the current firmware version)
•
System Reset (resets the unit to factory default settings)
Other Information
USB Devices / SD Cards
When playing audio files, note the following:
•
DN-F350 does not charge any connected USB device or SD card and does not support USB hubs or USB extension cables.
•
DN-F350 supports USB devices that are mass storage class or compatible with MTP.
•
DN-F350 supports FAT16 or FAT32 file systems only.
•
You can have up to 999 folders and up to 8 folder levels, including the root directory.
•
You can have up to 999 audio files. If the USB device or SD card contains more than 1000 files, some audio files may not play or appear correctly.
•
File names, folder names, and text characters can use up to 255 characters. Only uppercase letters, lowercase letters, numbers, and symbols can
be displayed. Japanese file names will not be shown. File names that begin with a "." will not be shown.
•
Copyright-protected files might not play properly and/or may appear as Unknown File.
When playing audio files on a USB device or SD card, DN-F350 supports the following tag data:
•
ID3 tags: Version 1.x and 2.x
•
for MP3 files:
Sample rate: 44.1 kHz
o
Bit rate: 64 kbps to 320 kbps
o
Format: MPEG1 Audio Layer 3
o
File extension: .mp3
o
• WAV
Sample rate: 44.1 kHz
o
Bit rate: 16 bit
o
• FLAC
• MP2
• M4A (without DRM protection)
• WMA (without DRM protection)
• AIFF
Audio File Playback Order
Audio files on an SD card are organized and will play in the same order in which they were added to the SD card. Audio files on a USB device are
organized and will play in order of the file name. (This order may appear differently on your computer and/or in your software than it does on the unit.

Updating the Firmware

1. Go to the denonpro.com
2. Put the firmware file in the Root Directory of a USB drive; be sure to unzip the file so it appears outside any folders on the drive.
3. Power on the DN-F350.
4. Press the Source button to select "USB".
5. Set the rear panel Operation Switch to "Update".
6. Insert the USB drive with firmware into the USB port on the rear panel.
7. When the unit prompts to update the firmware, press the Play/Pause button on the front panel. You will see the update status on the screen. After
the update is complete, the DN-F350 will reset and normal operation will occur.
products page to see if there are any available updates to download for the DN-F350.
11