Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
1
Insert the bit all the way into the collet cone. Press the
shaft lock to keep the shaft stationary and use the
wrench to tighten the collet nut securely.
To remove the bit, follow the installation procedure in
reverse.
OPERATION
Set the tool base on the workpiece to be cut without the
bit making any contact. Then turn the tool on and wait
until the bit attains full speed. Move the tool forward over
the workpiece surface, keeping the tool base flush and
advancing smoothly until the cutting is complete.
When doing edge cutting, the workpiece surface should
be on the left side of the bit in the feed direction.
1
2
3
1. Workpiece
3. View from the top of the
tool
NOTE:
•
Moving the tool forward too fast may cause a poor
quality of cut, or damage to the bit or motor. Moving
the tool forward too slowly may burn and mar the
cut. The proper feed rate will depend on the bit size,
the kind of workpiece and depth of cut. Before
beginning the cut on the actual workpiece, it is
advisable to make a sample cut on a piece of scrap
lumber. This will show exactly how the cut will look
as well as enable you to check dimensions.
•
When using the straight guide or the trimmer guide,
be sure to install it on the right side in the feed
direction. This will help to keep it flush with the side
of the workpiece.
003669
1. Shaft lock
2. Bit
2
2
4
4
2. Bit revolving direction
4. Feed direction
1
Straight guide (optional accessory)
The straight guide is effectively used for straight cuts
when chamfering or grooving.
Screw the guide bars into the holes in the tool base.
001984
Install the straight guide on the guide bars and adjust the
distance between the bit and the straight guide. At the
desired distance, tighten the wing bolts to secure the
straight guide in place.
1
3
When cutting, move the tool with the straight guide flush
with the side of the workpiece.
5
001985
1. Feed direction
2
3
2. Bit revolving
3. Workpiece
4. Straight guide
4
003676
003680
1. Screwdriver
1
2. Guide bar
2
003681
1. Straight guide
2
2. Guide bar
3. Wing bolt
direction
Publicité
Table des Matières
