Setting Parameters - Gram K1 Manuel D'utilisation

ECF-1 Check maximal load (span) Press
ECF-2 Zero calibration
ECF-3 Span calibration

SETTING PARAMETERS

1. To access to setting parameters, with indicator turned off, press and hold the
without release it, press the
2. When countdown is finished, the display will show P0000, press the
digit flashes P0000, then press two times the
3. Press the key, the display will show LF1.
4. Use the key
key continuously during the initial countdown.
to select the LF1 or LF2 modes and press
, display will show CALZ, empty the
platform and press again the
display reading to zero
Press key
Press to enter the value.
Put a weight on the platform and press
to confirm and exit.
Press key, display will show CALZ, empty
the platform and press again the
display reading to zero and exit.
+
Press key
Press key.
Press to enter the value of calibration
weight. .
Put the calibration weight on the platform and press
to confirm and exit.
key, the display will show P0020.
key to put
l key to put
a and
key until the third
to enter to desired mode.
key
10